Theses and Dissertations
The propagation of medium pressure disturbances in high subsonic air flow.
(Rensselaer Polytechnic Institute, Troy, N.Y., 1951)
Evaluation of the damping capacity of a cold-rolled SAE 1020 steel.
(Massachusetts Institute of Technology, 1955)
Since the first observation of the ability of a material to absorb
vibrational energy, engineers and physicists have looked upon this
property as the possible key to the behavior of materials under dynamic
loading ...
Stress distribution in pipe ells with straight end extensions under internal pressure
(Monterey, California: U.S. Naval Postgraduate School, 1954)
The experimental investigation of stresses in steel pipe ells under internal static pressure, herein reported, was conducted at the U. S. Naval Postgraduate School from January to April 1954.
Stresses in pipe ells under internal pressure
(Monterey, California: U.S. Naval Postgraduate School, 1953)
This paper is the result of investigating stresses in five samples of steel pipe bends -which were furnished the United States Naval Postgraduate School, Monterey, California, as a result of an offer by Dr. John E, Brock, ...
A method of incorporating bend flexibility factors in models for piping flexibility analysis.
(Monterey, California: U.S. Naval Postgraduate School, 1958)
The preparation of a superalloy with controlled porosity
(Monterey, California: U.S. Naval Postgraduate School, 1953)
A pile oscillator for the AGN 201 reactor.
(Monterey, California: U.S. Naval Postgraduate School, 1959)
Matrix analysis of elastic structures.
(Monterey, California: U.S. Naval Postgraduate School, 1959)
The mechanism of radial compressor instability
(Troy, New York; Rensselaer Polytechnic Institute, 1951-05)
The limit imposed on the operating range of a radial flow compressor by surging or pulsations in the reduced flow region has long been a source of concern to design engineers who would like to use this otherwise simple, ...
An investigation of the buckling caused by compressive forces existing in a thin elastic sheet, with a hole in the center, subject to uniform tension at two edges.
(Monterey, California: Naval Postgraduate School, 1957., 1957)
In a thin elastic sheet, with a hole in the center, subject to
uniform tension on two opposite edges, a small area at the rim of the
hole along the diameter of the hole parallel to the tension is in
compression ...
Refine By:
Advisor
Author
Branch Of Service
Date Issued
Degree
-
Masters (83)
Department
-
Mechanical Engineering (83)