MEMS-Scale Turbomachinery Based Vacuum Roughing Pump
Gannon, Anthony J.
Hobson, Garth V.
Shea, Michael J.
Clay, Christopher S.
Millsaps, Knox T.
MetadataShow full item record
This study forms part of a program to develop a micro-electro-mechanical systems (MEMS) scale turbomachinery based vacuum pump and investigates the roughing portion of such a system. Such a machine would have many radial stages with the exhaust stages operating near atmospheric conditions while the inlet stages operate at near vacuum conditions. In low vacuum such as those to the inlet of a roughing pump, the flow can still be treated as a continuum; however, the no-slip boundary condition is not accurate. The Knudsen number becomes a dominant nondimensional parameter in these machines due to their small size and low pressures. As the Knudsen number increases, slip-flow becomes present at the walls. The study begins with a basic overview on implementing the slip wall boundary condition in a commercial code by specifying the wall shear stress based on the mean-free-path of the gas molecules. This is validated against an available micro-Poiseuille classical solution at Knudsen numbers between 0.001 and 0.1 with reasonable agreement found. The method of specifying the wall shear stress is then applied to a generic MEMS scale roughing pump stage that consists of two stators and a rotor operating at a nominal absolute pressure of 500 Pa. The zero flow case was simulated in all cases as the pump down time for these machines is small due to the small volume being evacuated. Initial transient two-dimensional (2D) simulations are used to evaluate three boundary conditions, classical no-slip, specified-shear, and slip-flow. It is found that the stage pressure rise increased as the flow began to slip at the walls. In addition, it was found that at lower pressures the pure slip boundary condition resulted in very similar predictions to the specified-shear simulations. As the specified-shear simulations are computationally expensive it is reasonable to use slip-flow boundary conditions. This approach was used to perform three-dimensional (3D) simulations of the stage. Again the stage pressure increased when slip-flow was present compared with the classical no-slip boundaries. A characteristic of MEMS scale turbomachinery are the large relative tip gaps requiring 3D simulations. A tip gap sensitivity study was performed and it was found that when no-slip boundaries were present the pressure ratio increased significantly with decreasing tip gap. When slip-flow boundaries were present, this relationship was far weaker.
The article of record as published may be found a http://doi.org/10.1115/1.4027971Approved for public release; distribution is unlimited.
Showing items related by title, author, creator and subject.
Shea, Michael J. (Monterey, California. Naval Postgraduate School, 2012-06);This study forms part of a larger study to develop a MEMS scale turbomachinery based vacuum pump. This would allow very high vacuum to be drawn for handheld mass spectroscopy. This thesis concentrates on the roughing portion ...
Vincent, Patrick J. (Monterey, California. Naval Postgraduate School, 2007., 2007-06);This dissertation presents a system-level approach for minimizing the power expended in achieving communication between a ground-based sensor network and an overhead Unmanned Aerial Vehicle (UAV). A subset of sensor ...
Girsang, Paruntungan (Monterey, California. Naval Postgraduate School, 1994-03);Structure Query Language (SQL) and Query By Example (QBE) are the most widely used query languages for Relational Database Management Systems (RDBMS's). However, both of them have problems concerning ease-of-use issues, ...